Elysol laying
 |
CUTTING THE SHEETSThe Elysol sheets can be cut using a high-speed circular saw with small teeth, or a jigsaw or shears, making sure to support the sheet near the cutting point and to remove any dust generated. |
 |
OVERLAPPING THE SHEETSThe laying sequence is always from bottom to top and in the opposite direction to the prevailing winds. Allow for an overlap of one wave or one rib on the sides, and a minimum distance of 120 mm along the length. Always lay the UV-protected side towards the outside. |
 |
FIXING THE SHEETSThe Elysol sheets must be fixed at the top of the wave or rib using the screws and gaskets supplied. To correctly fix the sheets, drill a hole that is 3 mm larger in diameter than the screw, in order to compensate for thermal expansion of the sheet. To seal the sheets, only use neutral silicone; to clean, use water and neutral soap. |
 |
The polycarbonate sheets cannot be walked on. |
Via Rivera, 50
20841 Carate Brianza (Italy)
Tel. +39 0362.9160.1
Fax +39 0362.990457
info@brianzaplastica.it
P.iva: IT00698250966
Capitale sociale: 3.000.000 i.v.
Reg. Imprese 00865040158
Rea: MB/602163
Privacy policy
